Voltronic Power 1K Betriebsanleitung

Stöbern Sie online oder laden Sie Betriebsanleitung nach Unterbrechungsfreie Stromversorgungen (USVs) Voltronic Power 1K herunter. Voltronic Power 1K Operating instructions Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
6 hours
1. Product Overview
Front View:
Back View:
750/1K VA
Schuko Type I French Type I French Type II Schuko Type II IEC Type
NEMA Type I NEMA Type II UK Type Universal Type S. Africa Type
1.5K/2K VA
Schuko Type NEMA Type I NEMA Type II IEC Type
Output receptacles Modem/Phone/Network surge protection
AC input RS-232 com. port
Circuit breaker USB com. port
3. Installation and Initial Startup
NOTE: Before installation, please inspect the unit. Be sure that nothing inside
the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow.
Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT
operate the UPS where the temperature and humidity is outside the specific limits. (Please
check the specs for the limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best results,
suggest to charge the battery at least 6 hours before initial use.
The unit charges its battery while connecting to the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the
power switch of UPS unit, then devices connected to the UPS will be protected by UPS unit.
Connect Modem/Phone/Network for Surge Protection
Connect a single modem/phone line into surge-protected “IN” outlet on the back panel of
the UPS unit. Connect from “OUT” outlet to the computer with another phone line cable.
Connect Communication Cable
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB/RS-232 port and the other to the communication
port of your PC. With the monitoring software installed, you can schedule UPS
shutdown/start-up and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again
the power switch.
4. Important Safety Warning (SAVE THESE INSTRUCTIONS)
Please comply with all warnings and operating instructions in this manual strictly. Save this
manual properly and read carefully the following instructions before installing the unit. Do
not operate this unit before reading through all safety information and operating instructions
carefully.
CAUTION! Please transport the UPS only in the original package to protect against shock and impact.
CAUTION! To prevent the risk of fire or electric shock, install in a temperature and humidity controlled
indoor area free of conductive contaminants. (See the specifications for the acceptable temperature and
humidity range.)
CAUTION! To reduce the risk of overheating the UPS, do not cover the UPS' cooling vents and avoid
exposing the unit to direct sunlight or installing the unit near heat emitting appliances such as space
Line Interactive Sinewave UPS Quick Guide V. 1.2
Input voltage
Output voltage
AC mode indicator
Load level
Overload indicator
Battery mode indicator
Battery level
Low battery indicator
Fault indicator
LCD panel
Power switch
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - 1. Product Overview

6 hours 1. Product Overview Front View: Back View: 750/1K VA Schuko Type I French Type I French Type II Schuko Type II IEC Type

Seite 2 - 7 Specifications

heaters or furnaces. CAUTION! Do not attach non-computer-related items, such as medical equipment, life-support equipment, microwave ovens, or vacuum

Kommentare zu diesen Handbüchern

Keine Kommentare